Miata VVT solenoid Swap harness pre wired

Product Information

2 pin wiring harness for your 1.8 VVT swapped miata!
Includes a genuine mazda vvt solenoid connector with a 1,5 meter (1 meter sleeved) harness that you connect straight to your (preferably) Engine control unit (ECU).

Wiring harness has a Red and Blue wire.
Pinout: 
Red wire: 12 Volt switched
Blue wire: VVT signal.

The signal pin is to be connected to an output on your ecu like LS1 pin on an ME221,ME442 or AUX1 on an ecumaster ECU etc.

Note 1; This is just the harness, it does not include the VVT solenoid nor is it the only wiring harness needed for the 1.8 VVT swap into non VVT chassis. 

Note 2: 
Install the SB340 Flyback diode as shown in the image to prevent ECU voltage spikes and damage to your ecu.